Return the tension to normal by turning the screw to the right as far as it will go and then to the left until the white setting mark appears at the notch in the bobbin holder. Fit the small screwdriver into the hole under the slide plate and turn it to the right to tighten the tension. Before adjusting, note the position of the white setting mark beneath the bobbin holder notch. Tighten the needle thread tension by moving the dial to a higher number.Īdjusting bobbin tension Special sewing techniques such as pin tucking may require tighter bobbin tension. The needle thread is too loose if the needle thread appears on the bottom surface of the fabric. Loosen the needle thread tension by moving the dial to a lower number. If the needle thread is too tight if the bobbin thread appears on the upper surface of the fabric. You may need to set the needle thread tension between “6”-“9” for sewing techniques such as automatic gathering or overlocking. Set the needle thread tension between “2”-“4” when sewing buttonholes, applique and automatic machine embroidery for smoother, satin finish on the right side of the fabric. When sewing soft flimsy fabrics such as chiffon, batiste, jersey, tricot and silk like synthetics set tensions between “2”-“4”. Normal needle thread tension is “2” to “6”. Use the same thread through the needle and in the bobbin. New Home 6000 Memory Craft Sewing Machine Instruction Manual.īalancing needle thread tension You should always test the needle size, pressure and tension on a piece of fabric that will be used for actual sewing.
0 Comments
Leave a Reply. |